Dacor ERV48ER Manuale di Installazione

Installation InstructionsDowndraft Raised VentModels: ERV30, ERV36, ERV48 PRV30, PRV36, PRV46Part No. 65335 Rev. HUse these downdraft raised vents

8Cut and remove the foil material inside the knock-out 2. hole. If you fail to remove the foil, the vent will not work.If the unit will vent through t

9Gently slide the vent into the rear of the countertop cut-5. out with the electrical access panel toward the front.Loosely attach the anchoring legs

10Installation InstructionsGroundPowerInputBlowerOutputElectrical access panelRaised Vent Electrical Access PanelRaised Vent Front ViewTo power wiri

11Installation InstructionsExample of Installation with Bottom Exhaust(Side View)REMP16 remote blowerConnect wires/conduit according to remote blower

12Installation InstructionsVerifying Proper Operation WARNINGRead the raised vent use and care manual complete-•ly before operation.Install all of th

13Wiring DiagramSTUDCHASSISGROUNDGROUNDPOWERINPUTBLOWEROUTPUTGNDL2 N1L1N2 GNDCOMCOMNONOUPPERLIMIT SWITCHLOWERLIMIT SWITCHCOM NCNONCNCREMOTE POTSNORKEL

Dacor ● Phone: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.com

Installation Instructions ... 8Installation Preparation ...

1Important Information About Safety InstructionsThe • Important Safety Instructions and warnings in these instructions are not meant to cover all pos

2Important Safety InstructionsDo not install or operate a damaged appliance. If you •receive a damaged appliance, contact your dealer or builder.Obse

3Product DimensionsProduct Specifications30 ¼"(768 mm)to37 ¼"(946 mm)10"(254 mm)30"(762 mm)18 5/8”(473 mm)5/16” (8 mm)thick stiffe

4The customer must supply 3 conductor wiring/conduit •with minimum current carrying capacity of 8 Amps. to supply power to the remote or in-line blow

5Installation SpecificationsVerticalnon-combustiblesurface rear wallNotches for self-rimmingstyle installations, see range installation instructionsNo

6Installation SpecificationsWhen connecting the duct work to the back of the unit, •the customer must supply a 3 ¼” X 10” rectangular transition to m

7On side exhaust installations, allow five inches of space •on the side for the ADT2 exhaust transition plus addi-tional space for the duct attached