Dacor ERV48 Specifiche

Installation InstructionsDowndraft Raised VentModels: ERV36-ER, ERV48-ERUse these downdraft raised vents only with approved Dacor ® appliances.See the

Installation PreparationVerify Package Contents• Product literature• Anchoring legs• 2 wood screws, #14 x 2 1/2 (PN 83047)• 3 wire nuts• ADT2 duct tra

5. Gently slide the vent into the rear of the countertop cut-out with the electrical access panel toward the front.IAnchor leg\ITop of vent restingon

Electrical Installation 1.[_ WARNING• ELECTRIC SHOCK HAZARD - Do not connect theraised vent power plug to the electrical outlet untilinstallation is c

REMP seriesremote blowerConnect wires/conduit /according to remote blowerinstallation instructionsRaised vent\RangeSee ERV electricalaccess panel onfa

Verifying Proper OperationWARNING, Install all of the front filters prior to operating theraised Vent! Refer to the use and Care manua for ill,ter ins

DOWN UPUMITSWITCH UMITSWITCHSNORKEL SWITCHREDWHTBLUEREMOTEPOTIREDBLUERELAYCOMNO NCCHASSISGROUNDSTUDWHTI_2 N2 LI NI GND GND0 0 0 0 0 0ORNGN COM NOISPEE

The Life of the Kitchen?Family OwnedAmerican MadeDacor • 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 • Phone: (800) 793-0093 • Fax: (626)403-3130

Important Safety Instructions ... 1Important Information About Safety Instructions ... 1Safety Symbo

Important Information AboutSafety InstructionsThe Important Safety Instructions and warnings inthese instructions are not meant to cover all possiblep

General Safety PrecautionsTo reduce the risk of fire, electric shock, serious injury or death when using your appliance, follow basic safety precau-ti

Product Dimensionss/II\\-" +1 _ t/4" I'"," 1(6 mm) I ",, 5/16" (8 mm) l _ _1 ,," thick stiffener I I- '_

WARNINGobserve all governing codes and ordinances duringplanning and installationl Contact your local buildingdepartment for further information.The e

The raised vent exhaust may be configured to ventthrough the back, the bottom or through one of thesides. The maximum allowable duct run must be taken

Planning the Duct WorkWARNING• To reduce the risk of fire and to properly exhaust air, be sure to duct air outside the house or building. Do not vente

On side exhaust installations, allow five inches of spaceon the side for the ADT2 exhaust transition plus addi-tional space for the duct attached to i