Dacor ERV48 Specifiche Scaricare il pdf (Pagina 10)

Installation Preparation

Verify Package Contents

• Product literature

• Anchoring legs

• 2 wood screws, #14 x 2 1/2 (PN 83047)

• 3 wire nuts

• ADT2 duct transition

• 2 sheet metal screws, #10 x 1/2 (PN 83022)

• 2 keps nuts, 1/4-20 (PN 83049)

• 2 flat washers, 1/4-20 (PN 83203)

• Insulation foam

Installation

WARNING

• If the electrical service (electrical outlet) does not

meet the Electrical Specifications on page 4, do not

proceed with the installation. Call a licensed electri-

cian and have an electrical outlet installed that meets

the specifications.

Install the vent only in a vertical orientation. Do not

mount the vent on a slant or angle.

Do not enlarge or modify the exhaust knock outs or

cut an exhaust hole in a location on the chassis other

than those shown. Doing so may cause an increase

in noise and decrease performance.

NOTE: The ERV series raised vent installs in the back of

the cutout, separate from the range. Install the raised vent

before pushing the range into place.

Installing the Raised Vent

1. Remove the appropriate side, back or bottom exhaust

knockout, depending on the desired exhaust configura-

tion, from the raised vent chassis by cutting the metal

cross overs and removing the insert.

Side -_

knock-out

Back of unit

_Side

knock-out

Rear knock-out with

metal cross overs

._ shown

]'-

Bottomknock-out

Vent Knock-out Locations - Rear View

Cut and remove the foil material inside the knock-out

hole. If you fail to remove the foil, the vent will not work.

If the unit will vent through the bottom or side:

• Attach the supplied ATD2 transition to exhaust

location with the provided sheet metal screws.

I I

ADT2 bottom

installation

ADT2 side

installation

ADT2 Transition Installation

For bottom installations cut a hole in the cabinet

floor to allow the exhaust transition and/or the duct

to pass through the floor.

Top of vent resting

on countertop

Cut hole in floor to allow

duct to pass through on

bottom venting installations

Floor

If the unit will exhaust air from the back, attach a

3 1/4" X 10 duct to the vent hole created by removing

the knock-out on the back of the unit.

8 _mC_

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Commenti su questo manuale

Nessun commento

Dacor ERV48 Specifiche Pagina 10

Commenti su questo manuale

Prodotti e manuali riguardandi Fornelli Dacor ERV48