Installation InstructionsRenaissance® Integrated Ventilation SystemsModels RNIVS1, RNIVS2, RNIVSR1, and RNIVSR2Part No. 109408 Rev. A
9Product SpecificationsProduct Dimensions All tolerances are +1/16”, -0” (+0.16, -0 cm) Rear View3/8”2 1/8”back panel(5.04 cm)channel depthchanne
10Preparation and SetupParts ListBACBECFGGHFSTAINLESSSTEELCLEANERHAERNIVS InstallationPhillips screwdriver Drill + bits JigsawFlathead screwdriverTape
11Preparation and SetupMeeting Installation Requirements WARNINGObserve all governing codes and ordinances during planning and installation. Contact y
12Preparation and Setup WARNINGMake sure electrical service to the RNIVS is installed by a licensed electrician.It is the owner’s responsibility to co
13Preparation and SetupDuct Length Calculation TableThe maximum straight duct length for the hood is deter-mined by the type of duct used. See the cha
14Installation InstructionsAssembling the FiltersFilters are boxed separately and must be assembled during installation. All knobs and hardware are in
15Installation InstructionsThe Renaissance® series (RN) Integrated Hood Liner (RNIHL) is available separately and must be installed before the RNIVS.T
16Installation InstructionsTwo 8-inch duct exhausts can be transitioned into one 10-inch duct. • Attach the Dacor transition kit # ATD10 before insta
17These measurements and marks are for centering the RNIVS and marking the duct cutouts.Have a marking tool and tape measure ready.1. Mark the center
18Installation Instructions WARNINGInstalling the RNIVS requires two people. Do not attempt to lift and hold the RNIVS without assistance.Wear protect
1Planning the Ductwork ... 13Installation Instructions ...
19Installation InstructionsAdding a SpacerChannel DimensionsIf using the RNIVS without a liner kit, use a 3/8” spacer:The flange circling the bottom
20Installation Instructions WARNING• To avoid electric shock or fire hazard, make sure that power to the RNIVS power supply line is turned OFF at the
21Installation Instructions WARNING• Do not ground the circuit to a gas line.• Do not ground the circuit to a hot water pipe.• Water lines that are
22Make sure dimmable bulbs are used. The electronic board is designed for dimmable light bulbs and using non-dimma-ble types will cause damage and fau
23Verifying the SetupVerify the setup to ensure everything functions correctly:1. Turn the power ON at the circuit panel or fuse box.2. Assemble the
24The Installation Checklist WARNING• To ensure a safe and correct installation, the follow-ing checklist should be completed by the installer to ens
25Wire DiagramsRNIVS1 & RNIVSR1 RNIVSR1 DOES NOTHAVE A FAN IN THEBWGBBBBWFORCONNECTIONTO ARLC/ARSC/ARSLCFORCONNECTIONTO REMOTEBLOWER P/N:ILHSF -8/
26Wire DiagramsRNIVS2 & RNIVSR2 RNIVSR2 DOES NOTHAVE A FAN IN THEWGBFAN MOTORLAMPDIMMERFANSWITCHFAN MOTORREV A109391DACOR P/N:CAUTION: DISCONNECT
Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.com
2Important Information About Safety Instructions• The Important Safety Instructions and warnings in these instructions are not meant to cover all pos
3Important Safety InstructionsGeneral Safety PrecautionsTo reduce the risk of fire, electric shock, serious injury or death when using your appliance,
4• Do not install or operate this RNIVS if it has been damaged, dropped, has damaged electrical wires or is not work-ing properly. If the product is
5All ModelsFeatures DescriptionFilters Baffle style, Dishwasher safeLightsDimmable LED 7.5 Watt, 60 Hz. Compatible with Halogen or any dimmable, 75W m
6Product SpecificationsProduct Dimensions Top Centerline Dimensions8 7/8”18 1/2”19 5/8”20 1/4”21 7/16”(22.5 cm)(46.92 cm)(49.82 cm)(54.43 cm)(5
7Product SpecificationsAll tolerances are +1/16”, -0” (+0.16, -0 cm) Product Dimensions Detail.40flange3/8”(1.0 cm)3/8” Rear Flange Extension3/8
88 7/8”(22.5 cm)18 1/2”19 5/8”(46.92 cm)(49.82 cm)30 1/4”(76.84 cm)31 7/16”(79.83 cm)RNIVS2 & RNIVSR2 DimensionsCL6 3/16”(15.72 cm)5 3/4”(14.54 cm
Commenti su questo manuale